FIAT Panda - Asb light on dashboard.

Honest John Back Room » Technical matters
What is life like with your car? Let us know and win £500 in John Lewis vouchers | No thanks
View Threaded
Sat 28 May 2016 23:22
FIAT Panda - Asb light on dashboard. - Bellibear

I have a fiat panda 1.2 2008 and my abs light came on my dashboard. I used an icarsoft diagnostic kit and it says i had a fault asb sensor rear left wheel. I replaced the sensor and the light went out but went i set off after a few miles it came on. So i use my diagnostic kit to delete the error and it went off but came on again after a few miles. So iv tried to disconnect the battery left it over night and connect it again then started the car and let it run for more then 5 mins. But still the light comes on after a few miles. There no other faults coming up so any ideas what the problem might be.

Thanks in advance.

Reply | Report as offensive | Link
Sat 28 May 2016 23:37
FIAT Panda - Asb light on dashboard. - elekie&a/c doctor
As I have always said,fault codes are only a rough guide.More in depth investigation needed.Could be wheel bearing fault,wiring or control unit problems.Remember,computers are clever but they have no brain.!
Reply | Report as offensive | Link
Sun 29 May 2016 01:26
FIAT Panda - Asb light on dashboard. - Bellibear

Does the panda have a abs ring in the bearing because we had the bearing off to and iv been reading if it put on backwards it will cause a fault

Reply | Report as offensive | Link
Sun 29 May 2016 09:37
FIAT Panda - Asb light on dashboard. - elekie&a/c doctor
The bearing has only one magnetic face,so if you have fitted it back to front,this could be your problem.
Reply | Report as offensive | Link