I would take the tyre off, drop the psi by 15psi-20psi and using body weight, press on the tyre while it's submerged. and turn the tyre...repeat the leak might only show when the car's weight is on the tyre hth Liam
ps or long winded, jack the wheel up place a tub of water underneath (deep enough to cover the tyre and rim ) , and lower the wheel then jack it up , turn the wheel 1/6th, drop it again etc
Good thinking.
But suppose it only leaks on the upper (un-immersed) side and when it gets to the submerged side the weight of the car seals it?
Unlikely, perhaps, but never underestimate the Might of Murphy.
Ratchet strap through the wheel centre, round some kind of board (sand-ladder or ramp would be almost purpose built.) Paddling pool or rubber dinghy, but the tyre will float, and if you ballast it you'll alter the loadings.
Failing that, clean river or lake/loch (Scotalnd or Wales probably favorite), preferably in the winter to lower the algae count.
Good wetsuit, mask and schnorkel. Or alternatively, wimp out and remotely monitor with a camera.
But the tyre will still experience buoyant forces.
International Space Station and a perspex tank, or just a big water-filled polythene bag. Needn't be very strong.
Job done.
Phew!.
You could perhaps calibrate the ratchet strap with a strain guage, but that might be a little over the top.
|