My 2017 MG has excessive pitting on the rear discs - is this covered under warranty?

When starting my 2017 MG GS from cold the rear pads do not seem to disengage fully resulting in a rubbing/grinding noise until they warm up. I have told I now have excessive pitting on my disks. Can I...

Soft brake pedal on Ford Focus - what's the cause?

Any ideas please on a soft/long brake pedal on a 2014 Ford Focus 1.6 diesel. I have bled the brakes and the pedal is better but then gets softer over the course of the next two/three weeks? I have checked...

When should I change my brake pads?

I’ve just had my BMW X6 serviced. They stated that my four brake pads are between 5.6 mm and 9mm and that BMW recommends changing them at 5mm. What is the legal requirement for changing them as opposed...

Why does my Subaru have an intermittent ABS fault?

My Subaru Outback ABS and traction light keeps coming on. The dealer had a quick look with a diagnostic tool that gave the pump as a problem. It then went off for a week. It has come on and off several...

Above 65mph the brakes on our car are very resistant when being pressed - what's the problem?

My son has a Mitsubishi Lancer which appears to run very well. However above 65mph the brakes seem to be very resistant when being pressed and need extra foot pressure, this can sometimes result in a sudden...

Will my car fail the MoT if a brake warning message is on the dash?

I have a Mercedes E 220 CDI 2006 model. I have recently replaced the front and rear brake pads and fitted new brake warning sensors but a brake warning message is still highlighted on the dashboard. Is...

How often should flexible brake hoses be replaced?

What is a reasonable point at which to replace flexible brake hoses? I have a low mileage 1998 MGF in excellent condition and with a well documented service history. While it has had brake fluid changes...

Is there a difference in performance between colours on brake calipers?

Is there a difference in performance between colours on brake calipers? Is red, or green better than black for example? Does the motor industry have particular engineering standards that apply to these...

If my car passed its MoT but has pitted brake discs should this be on my certificate as an advisory?

If my car passed its MoT but has pitted and scored brake discs, is this supposed to be on my certificate as an advisory?

Why won't the brakes on my Morris Minor work?

I have a 1970 Morris Minor truck. I have fitted a new master cylinder and renewed all of the brake lines. When I pump brakes I have nothing, I have rebuilt my old master cylinder but it is the same. When...