Hi Guys
I've got a Rover 218VVC Coupe which has a problem with the steering - the inside edges of the front tyres have been carved off and this appears to have been caused by the fact that there is a lot of play in the joint between the steering rack and the tracking control arm (offside). (This was found when I went to get the tracking checked).
Do you know whether this joint is adjustable or replaceable without removal/replacement of the complete rack?
I also have a couple of other questions related to this car:
1. It has a water leak in the boot. I am lead to believe that this is a common problem with this model but I don't know of anyone having cured it. Do you know whether it can be fixed and if so how?
2. I would like to fit a Rover roof rack to it but it appears I need to cut the door seal retainers in order to do so - is this correct and if so is it likely to cause more water leaks?
I'd be extremely grateful for any help/advice regarding any of these matters.
Thanks in advance
CF
|
I'll have a look right now for you.
MG-Rover Questions? forums.mg-rover.org/
|
Looking on the EPC it shows the inner joint but there is no part number or mention of it.
The only way out is "QEB000250 Rack assembly power assisted steering £410.50"
Nasty...
Boot leaks? Apply a dob of silicone sealant in and around the rear screen lower locating clips, there's two of them.
Roof rack? Never fitted or seen one on a Coupe before!
MG-Rover Questions? forums.mg-rover.org/
|
Thanks for your help - much appreciated!
I feared a new rack would be necessary :-(
Do you know whether that rack is the same for all of the 200/400 series with power steering or which other models use the same rack? (I'm just considering the possibility of a scrapyard part)
Thanks again
CF
|
DF There are mumerous steering gear reconditioners power or manual all around the country who will be able to satisfy your needs,for 25 to 30% of the cost of a new rack.It is well worth while searching one out. HTH tonyh
|
|