I have a problem with my mondeo TDci without any warning the car losses power and goes into limp home mode . If I stop and restart the car the ecu rebooted it resumes power . Sometimes I get warning bleeps from dashboard
The temperature gauge stays steady at the mid range normal,sometimes when the faults occur the temp drops down to the cold. I had the car diagnostic checked. the only code was P1288 recorded cylinder head temperature sensor,but the garage was unable to locate the item. Would this sensor cause the two problems I have .where is this sensor/ does this sensor control the temperature gauge?
|
The engine coolant temp sensor provides information to both the engine control ecu and the temp gauge,so yes,both problems are connected.Access to the sensor is a little tricky as it sits behind the auxiliary drive pulley at the end of cylinder head,gearbox end.This pulley drives the water pump and pas pump.hth
|
Many thanks I shall order the temp sender and get it fitted ASAP and report back
|
|