Ford Mondeo III (2000 - 2007) - 04 2.0 TDCI 115bhp, Need help Not starting

Honest John Back Room » Technical matters
View Threaded
Sun 10 Jan 2010 14:50
04 2.0 TDCI 115bhp, Need help Not starting - BigBuckz
I have a 2.0 TDCI 115bhp, I had the dual mass flywheel changed, with the full clutch kit, slave cylinder, crankshaft sensor. But the car will not start, it just doesn't start, sometimes it starts for about a second and then cuts of. Its been at the mechanic's for about 1 week now and they haven't found the cause. Could someone please help.
Reply | Report as offensive | Link
Sun 10 Jan 2010 15:10
04 2.0 TDCI 115bhp, Need help Not starting - sandy56
If the car was starting OK before these clowns worked on it then could be the crankshaft sensor is incorrectly setup?

Turns over ok?

Got fuel in it? getting fuel to the injectors? or has it frozen up?

Failing that I can only suggest that they take it to a proper garage, at their cost




Reply | Report as offensive | Link
Sun 10 Jan 2010 15:44
04 2.0 TDCI 115bhp, Need help Not starting - BigBuckz
Does the sensor have to be setup after replacing?

It turns over but doesn't start. Its got fuel and its not frozen at all.
Reply | Report as offensive | Link

Will you have to pay the low emissions charge?

Use our ULEZ checker to find out if your vehicle is subject to ULEZ charges. Simply enter your number plate into the Honest John ULEZ checker to see if you will have to pay to enter the London Ultra Low Emission Zone.

Check your vehicle