Im going to replace the standard radio in my 306. I have got the replacement facia plate but am unsure how to remove the standard radio.
Any advice would be greatly appreciated
Also the heater blower works but no air is coming out of any vents... is this a common problem? Am i going to have to strip the dash?
|
Did one a few weeks ago. The clips holding in the one I did was not the conventional ones, opened by 2 pieces of wire, but were open by 2 blades sliding in either side.
managed with a couple of old table knives, but I would make sure you get the correct pair of tools.
|
Hi
Pop down the Peugeot dealer & ask them nicely, you never know!
|
simple, look along thebottom of the radio's facia. There is 2 slightly indented flat pieces. difficult to spot until you look for them. Just push a couple of small flat screwdrivers in there, it will release the clips and you can pull the radio out.
|
|