Hi all, it finally it snapped off at the Cat end. I replaced it with a repair section that consists of the Flexi with a flange on one end to connect to the original exhaust and a sleeve section to go over the remaining pipe from the Cat.
I had to cut off the old bolts at the joint just past the Flexi then cut the pipe just past where the sensor screws in. This left about one and a quarter inches below the Cat to allow the repair section to slide over and be clamped.
You need to take the brace that goes across the bottom of the car off to give more access to cut the flange bolts off and get the old Flexi out.
There’s not a lot of room in the tunnel where you need to cut the pipe below the Cat but I managed it with a small cutting disc on a flexible drive driven by my electric drill.
Cost of the repair Flex was £64.40 from C.E.S Motor Factors, total for parts was about £68.00, not the easiest of jobs but better than replacing the Manifold, Cat and Flex. Plus no need to drop the Subframe.
Here is a YouTube video showing the parts and results. youtu.be/OfDMvim6CJE
|