What is life like with your car? Let us know and win £500 in John Lewis vouchers | No thanks
Ford Focus - Side sill curbing dent - Andrew Compton

Hi all

I have been a right idiot and driven into a curb in a multi story car park.

The dent is on the rear offside sill and is about 6 inches long and 2 inches deep.

Been looking around and some people have said;

fill it with filler ( my thought was wont this fall off on such a large dent)

It will have to be cut off and a new peice welded on

Or use a slide hammer ?

Please advive

Andrew

Ford Focus - Side sill curbing dent - elekie&a/c doctor

Take it to a body repair shop.They will have the correct gear to repair the damage.Or get youself one of these;www.ebay.co.uk/itm/SPOT-STUD-WELD-WELDER-DENT-PULL...X

Ford Focus - Side sill curbing dent - John F

If it's an old car I would drill a couple of small holes in it and pull it out with bent coathanger wire or similar. Then fill and paint.

Ford Focus - Side sill curbing dent - liammcl

A while back, someone was going around the neighbourhood denting all the cars..

ibb.co/cWwKLR

ibb.co/cM4jn6

Dunno , if you can take the panel off easily...but I had good results from gaffer tape round a tin of rice pudding.... and as a bonus , rice pudding for tea :)

ibb.co/fcnFum

I made enough of a gap between the outer shell and the body frame to get the tin down , and pushed the shell against the gaffer tape round hthe tin, so as not to get any sharp pressure on the shell.
a bit of force was needed , as can be seen by the dented top of the tin.

ibb.co/iwwKLR

ps the boiling water, and spray ice didn't work...damn you youtube ;)

All the best & good luck !
Liam

Edited by liammcl on 15/12/2017 at 01:02